DVD-quality lessons (including tabs/sheet music) available for immediate viewing on any device.
Take your playing to the next level with the help of a local or online resonator guitar teacher.
Monthly newsletter includes free lessons, favorite member content, resonator guitar news and more.
|
Please note this is an archived topic, so it is locked and unable to be replied to. You may, however, start a new topic and refer to this topic with a link: http://www.resohangout.com/archive/59498
guitfiddler - Posted - 11/19/2024: 18:30:48
Hello everyone!
I have been playing dobro for a few years now, and have been a guitar technician for even longer. I recently purchased a new-to-me dobro by a builder named Jerry Shadrick out of central MO. It seems to be a well built guitar with a very resonant body.
I finally pulled the cone out today because it was original (20 years old) and I figured it might need to be replaced. When I pulled the cover plate, the cone was glued down… is that a normal thing to do to keep the cone aligned and intonated?
The tone pot was also unlike any other I’ve seen here or other places. It looks like a traditional tone pot towards the back, but is cut open on the front. Has anyone else seen this?
Anyway, I’m trying to decide if I should replace the cone or the spider, as the spider doesn’t seem super resonant and doesn’t have the slight raise to it that typical #14’s do. I forgot to take pictures of the cone and spider, but can in the future if anyone has any advice to offer after seeing it. Thanks!
(Also, the pic of the full body is an older pic, I already peeled the tape with fret numbers off haha. Struggling to upload pics, will soon)
Edited by - guitfiddler on 11/19/2024 18:39:25
docslyd - Posted - 11/19/2024: 19:53:30
When you say "tone pot" I think of a tone control (pot) on an electric guitar. I'm assuming that's not what you mean. If you're referring to the body cavity that houses the cone and spider that would be the soundwell. Some soundwells have a ring that supports the top of the guitar 360-degrees (like a banjo tone ring). Others are called "open" soundwell designs with dowels, or posts supporting the top of the guitar. Some even have a baffle, or part of the soundwell closed in with the other side open. All combinations are possible, particularly since we might not be familiar with the builder of that guitar. It is not normal for the cone to be glued in, nor should it be. You'll probably destroy the cone getting it out, just as well since you should replace it anyway. As much as possible, make sure the cone supporting ledge is truly round, and true flat. That means you'll have to remove any residual glue. If the spider is not stamped "#14", replace it as well and the bridge of course, while you're at it. More information on setup can be obtained here or on videos describing the sequence. Paul Beard used to have a set up video which you might be able to find used.
docslyd - Posted - 11/19/2024: 19:58:37
....by the way...and additionally: The alignment of the cone is only maintained by string tension. Therefore, only change your strings one at a time to avoid the cone moving out of position once it has been aligned and intonated. That's another story but I'm sure you can find tips on how to do that here on these pages.
billm67 - Posted - 09/05/2025: 08:25:20
I recently did this update to my recording king professional. The cone was metric and the hole was just barely too small for the beard legend cone. I sanded the edge of the hole for a couple of hours until the beard cone dropped in and used his #14 spider and wave bridge. Wow! What a difference. The recording king was very well constructed but with the legend cone and spider this guitar is fantastic! Very loud and great tone. I would suggest the beard parts for an update. You won’t regret it.
Terms of Use | Privacy Policy | Privacy Consent (EU/GDPR Only)
Copyright 2026 Reso Hangout. All Rights Reserved.